|
Vehicle Graphics
Application
Instructions
Customize
Graphic
Photo T-Shirts & more
Carnival
Signs
Feedback
Search
| |
Dry Method
Adhesive Backed Vinyl Application Instructions
-
Clean the surface well to avoid dust and oil under the
vinyl.
Wash first with water to remove any bugs or
tree sap.
Second you will need to clean with
alcohol
to remove any wax & rain x, then a final cleaning
with Windex.
-
Read all our directions first.
-
Without removing the backing, place decal exactly
in the position it is to be located.
-
Tape everything temporarily into place with masking tape.
-
Step back and see how it looks.
-
Once applied, it cannot be repositioned.
-
Measure twice to assure accuracy, measure from the flat areas on numbers
and letters.
-
Apply a piece of masking tape across the entire top edge, to make a hinge.
-
-
Fold the decal back along the tape hinge.
-
-
* Remove the backing, revealing the sticky side.
-
CAUTION: Do Not allow the decal to fall freely on the surface.
-
** Hold the decal away from the surface. With a squeegee (plastic
spatula, bondo applicator ...) carefully begin squeegee down the top 1 to
2 inches along the top edge. Work from the hinge down, squeegee down and
out over the remaining decal area, be careful not to trap
any air bubbles
behind the vinyl.
-
-
Remove the transfer tape by slowly peeling it back
from the decal.
-
-
The decal will remain in place if it has been firmly applied.
-
If any air bubbles appear, puncture with a pin and squeeze the area to
flatten the bubbles.
-
Tiny bubbles will disappear over time with the heat of the sun.
|
